Connect your Mr Beam to your router with a network cable (Ethernet). The network socket is located on the back under the USB ports.


Important: do not confuse the socket with the Air Filter System connection on the other side.


Important: a direct cable connection between your Mr Beam and the computer is not possible.



Make sure your computer is also connected to the router via cable or Wi-Fi.


After a few seconds (maximum 60 s), your Mr Beam will pulsate with orange lights. You can now access your Mr Beam via find.mr-beam.org


Tip: During the initial setup, your Mr Beam will guide you through the Mr Beam Welcome Dialog. If you wish to do so, you can set up a Wi-Fi connection with the router there.


Here is a short video in German on how to connect your Mr Beam with your computer: