The cutting speed is material dependent and ranges from ~60mm/min (cutting 3mm Kraftplex) to 1000mm/min (cutting 2mm felt). 

Engraving speed ranges from 100mm/min (anodized aluminum) to 2000mm/min (dark leather). 



Tip: To achieve clean edges, it is often better to have multiple passes with higher speed than going below 100mm/min. You will find more information on our article dedicated to laser parameters.


With the new Mr Beam II dreamcut [S] head, most materials can be processed up to 50% faster than with older models. What else is new, you can read in detail in this article.