Maintenance and hardware support
Everything around servicing, cleaning, maintaining, replacing parts and repair service for the Mr Beam.
There is a constant airflow along the beam down to the material which avoids smoke settling on the lens.
Wed, 18 Jul, 2018 at 7:47 PM
There should be a small maintenance now and then, the ruler bearing needs a few drops of oil and the floor could be cleaned as needed. Our laser diode has a...
Wed, 18 Jul, 2018 at 7:47 PM
Mr Beam Air Filter System has two filter parts, which need to be replaced from time to time: 1. a pre-filter (pre-filter mat) for rough particles,...
Thu, 14 Jan, 2021 at 2:05 PM
Why does the laser head get dirty in the first place and how do you know it is time to clean it? The dirt residue resulting from cutting and engraving ...
Wed, 12 Aug, 2020 at 10:09 AM
The mechanical parts of the Mr Beam II need to be cleaned and oiled approximately every 100 operating hours. You can find a counter of the operation hours i...
Wed, 16 Oct, 2019 at 10:45 AM
Important: Always switch off the device before moving or disconnecting the cable. Step 1: On the back of the laser head you will find a black clamp...
Tue, 29 Sep, 2020 at 6:15 PM