Camera

Everything around Mr Beam's device camera, from ensuring it works properly to various positioning options.

The Camera: General information
Mr Beam's camera is attached to the inner side of the orange lid and takes pictures of the working area in regular intervals. These pictures are t...
Fri, 25 Sep, 2020 at 2:01 PM
Manual Positioning
Positioning with the Mr Beam II camera is easy and quite accurate, sometimes though there might be a small deviation of up to +/- 5mm. If a laser job needs ...
Fri, 25 Sep, 2020 at 3:30 PM
Message: "Preview not accurate" and Pink Circles Flashing on Working Area
(Required software versions: MrBeam Plugin 0.6.9 or higher.) If the camera system was not able to detect all four pink circle markers that are inside th...
Fri, 25 Sep, 2020 at 3:29 PM
Camera Calibration: General information
Your Mr Beam's camera is factory calibrated by default, so there is normally no need to calibrate the camera. However, if you are experiencing problems...
Mon, 12 Oct, 2020 at 5:27 PM
Camera Calibration: Corner Calibration
The corner calibration is generally required if one of the pink markers has been removed, or if there is a bigger deviation between the screen picture and t...
Mon, 12 Oct, 2020 at 5:26 PM
Camera Calibration: Lens Calibration
If you have done a corner calibration, and the arrows you engraved for the corner calibration line up perfectly with the edge of the picture, but you still ...
Tue, 13 Oct, 2020 at 9:52 AM