Product information

What is laser cutting / engraving?
Laser cutting and engraving is a technique based on thermal material removal. Mostly used on (but not limited to) flat materials, its advantages are working...
Thu, 14 May, 2020 at 12:20 PM
What do I need for using the Mr Beam Lasercutter?
The Mr Beam II arrives fully assembled, calibrated, and ready to use. All you need for the first laser job is a laptop connected to wifi and a pre-installed...
Thu, 14 May, 2020 at 11:05 AM
Is Mr Beam II certified?
Mr Beam laser cutters have a CE mark. With this we (Mr Beam Lasers GmbH) as manufacturer declare in a legally binding manner that our laser cutters comply w...
Thu, 14 May, 2020 at 11:21 AM
Laser diode: technical properties
How long does the laser last? An expected usage time (= life time) of the laser is 10.000 hours. The life time doesn't decrease while you're not...
Thu, 14 May, 2020 at 5:38 PM
Power supply
How is Mr Beam powered? Mr Beam is powered with 110-240V, power consumption is 65W. What voltage does Mr Beam support? Power supply supports all volt...
Thu, 14 May, 2020 at 5:31 PM
Which platforms does Mr Beam support?
Mr Beam is platform-independent, which means you can use it with any operating system on any computer or tablet. The software is web-based and you can acces...
Fri, 15 May, 2020 at 2:29 PM
What is the working speed for cutting / engraving?
The cutting speed is material dependent and ranges from ~60mm/min (cutting 3mm Kraftplex) to 1000mm/min (cutting 2mm felt).  Engraving speed ranges from 10...
Thu, 14 May, 2020 at 5:53 PM
Can Mr Beam focus on different heights?
Yes, Mr Beam has a manual focus which must be adjusted according to the height of the material. The laser beam has a very steep angle, meaning the laser res...
Fri, 15 May, 2020 at 2:27 PM
Where can I find documents about the legacy products Mr Beam I Junior and Mr Beam I Senior?
Our legacy products Mr Beam I Junior and Mr Beam I Senior are no longer sold nor supported by Mr Beam. These products were sold only during our very first c...
Tue, 3 Mar, 2020 at 4:21 PM