Start a new topic

Engraving did stop

Everything went fine but on halfway the engraving did stop. You can see it in the video. What could be wrong?

1. Did the engraving job ever finish or can this stop be reproduced?

2. If not reproducable then you might have encountered the dreaded error 24 bug in GRBL (the basic firmware that MrBeam runs on) ... you may have a look in the log files to find something related to error 24, where you may see exact dates where such error may have occured.

Problem solved so far! After a small update from mr Beam!
Login or Signup to post a comment